Lightweight brace is ideal for patients of shorter stature.
Ideal to be used for knee ligament injuries / deficiencies.
Quick-release buckles for easy application and removal.
Safety Information
Carefully read fitting instructions and warnings prior to use.
To ensure proper performance of the brace, follow all instructions. Failure to properly position the brace and fasten each strap will compromise performance and comfort.
For single patient use only.
If you experience increased pain, swelling, skin irritation, or any adverse reactions while using this product, immediately consult your medical professional.
This device will not prevent or reduce all injuries.
Keep out of reach of children.
Consult your health care professional regarding safe and appropriate activity level while wearing this device.
Care and cleaning of this product is essential to its continuing strength and performance.
Follow removal and cleaning process described in instructions.
It is important to keep the brace clean to maintain proper brace function.
Feeding Table
null
Directions of Use
Refer enclosed manual for pictorial representation.
Unfasten buckles: Release all four straps on the back side of the brace by squeezing the gray levers on either side of the buckle and withdrawing the over-center buckle. Loosen the front straps.
Position the brace: With the knee bent at 45°, lay the brace on the leg and align the hinge as shown above. Position the center of the hinge on an imaginary line that goes across the top of the knee cap. Push the hinges posteriorly until the hinges are in the center of the knee joint when viewed from the side.
Anchor the brace: Wrap the upper rear calf strap around the calf as high as possible over the calf muscle. Insert the over-center tab into the base. Push the tab until you hear the hinge click on both sides.
Adjust the strap by releasing the tab and pull the strap until a snug and comfortable fit is achieved. All straps have additional length adjustment at the opposite end of each strap. (Z-12-D version: Feed the tab end of the strap through the D-ring. Tension the strap until a snug and comfortable fit is achieved).
Fasten lower calf strap: Insert the over-center tab into the buckle base on the lower calf shell of the brace. Push the tab in until both sides click locked. Adjust strap until a comfortable fit is achieved. (If the strap tab reaches its limit without achieving the desired fit, see next step for adjustment instructions). Center the strap pad.
Adjust strap length: All straps have additional length adjustment at the end opposite the tab. Release the strap and adjust the length of the strap using the hook and loop fastener.
Fasten rear thigh straps: Following the same instructions as in Step 4, fasten the lower and then upper rear thigh strap.
Adjust front tibia strap: Tighten the front tibia strap. If the strap overlaps too far, see Step 6 for adjustment instructions. Center the strap pad.
Adjust front thigh strap (PCL / Combined instability versions): Tighten the front thigh strap. (Note: Over tightening the front thigh strap can cause the brace not to function properly.) Stand up and walk or jog around to see how your new Z-12 brace feels.
Straps should not be so tight that blood circulation is restricted. Re-adjust as needed. If this is your first time to wear a functional knee brace, it might take a few hours of wear to get used to how it feels.
Adjust OA condyle pad: Press down on gray tab and slide into position for desired unloading. Adjust for comfort.
Preventive Note
Primary Prevention Ideal for mild knee instability or early ligament strain — provides dynamic control of tibial translation, helping stabilize the knee joint during movement and supporting confidence in daily activities. ·
Secondary Prevention Suitable for meniscal instabilities or moderate knee ligament injuries/deficiencies — offers enhanced structural support to reduce excessive joint motion, promote controlled mobility, and assist in protecting vulnerable tissues during rehabilitation. ·
Tertiary Prevention Recommended for significant ligament deficiencies or ongoing knee instability — delivers consistent dynamic stabilization, supports functional recovery, and helps maintain joint alignment and performance.
Description
Z-12 D is featured with a unique hinge-to-strapping system in a dual upright frame.
The frame contains spring steel reinforcement for extra shell strength.
Sport models are available with Hi-activity pads and D-rings.
Hi-activity pads feature an extra-grip material to assist in fit and suspension for impact activities.
Expert's Advice
Breg Z-12D combined stability provides dynamic control of tibial translation. Suitable for meniscal instabilities and knee ligament injuries / deficiencies.